Fast motor braking action:
Motor will stop rotate much faster than using only the mechanical switch, thanks to the fly-back diode. As a result, when shooting in single shot mode, spring will remain uncompressed after shooting, reducing stress and wear in your gearbox.

Eliminate electric arcing:
There will be no more current flowing in your mechanical switch, switching action will occur in the mosfet component, this will dramatically increase life shelf of you switch.

Reduced trigger response time:
Mosfet switch are far more efficient than mechanical system, you will feel the difference.

Increased rate of fire:
The Silverback Mosfet Motor Driver have a minimal resistance, motor will receive more power, leading to an increased rate of fire.

Built with high quality components:
IR Mosfet, ST Microelectronic Fly-Back Diode, custom design PCB, pre-soldered silver plated copper wire for low resistivity (with Teflon coating), 20cm length (should be enough for assembly on most of the available aeg).

Package include:
-Mosfet motor driver, with silver plated cable
-30cm of 26 AWG silver plated wire (to solder between one of the trigger contact and battery+)
-2 Motor connectors
-A small tamiya type battery plug
-Heat shrinkable tube

Do not use with batter with nomina voltage above 11.1 Volts
We recommend you to install a fuse (20 or 25 A) in your set-up

Material : COoper / Rubber / Plastic